VGSM Technology (M)
Sdn Bhd
Sdn Bhd
No.34G, 34A & 34B, Lorong Perda Selatan 1, Bandar Perda, 14000 Bukit Mertajam, Penang, Malaysia.
+604-538 1998
+604-530 1998
+604-530 1998
Vision Software
| Previous | 3 / 4 | Next |
The Aberlink Vision software module allows Aberlink 3D software to be used for non- contact measuring. Fully Automatic edge detection tools can be used in both manual and CNC mode ensuring fast and repeatable results without relying on the skill of the operator.
Powerful tools allow both geometric and complex shapes to be measured easily. Dimensions can either be called up by clicking on the measured features in the normal way, or alternatively measurement points can be best-fitted against a DXF file. As well as edge detection the operator may use either full cross hairs or mouse cross hairs with other advanced tools available including “smart measure”, centre line detection, an “all edge points” function, a “thread measure” tool and a “screen ruler” for quick measurements between any two points on the image.
Powerful tools allow both geometric and complex shapes to be measured easily. Dimensions can either be called up by clicking on the measured features in the normal way, or alternatively measurement points can be best-fitted against a DXF file. As well as edge detection the operator may use either full cross hairs or mouse cross hairs with other advanced tools available including “smart measure”, centre line detection, an “all edge points” function, a “thread measure” tool and a “screen ruler” for quick measurements between any two points on the image.
| Key Features | |
|
|